Ferro-Grad Ferritin Level Test

Feeling Tired? It could be low iron

Ferritin reflects "stored iron" or "available iron for use".

The Ferro-grad Ferritin Rapid Test is a quick, accurate and easy to use test to screen and monitor your ferritin levels at home, to aid in the diagnosis of iron deficiency anemia.

- Fast: results in 5 minutes

- Reliable: Overall accuracy at 97%.

- Easy single procedure

The Ferro-grad Ferritin Rapid Test Cassette can be performed in case of common symptoms of iron deficiency such as:

- Tiredness

- Headaches

- Paleness

- Faster heartbeat

- Shortness of breath

- mainly, if woman, when pregnant or in case of excessive bleeding during periods

This test kit is intended to be used as a preliminary test only and results should be discussed with a doctor or medical professional.

The Ferro-grad Ferritin Rapid Test is a rapid test for the qualitative detection of ferritin in human fingerstick blood, to aid in the diagnosis of iron deficiency anemia.

For self-testing in vitro diagnostic use only.

Boxed Contents: 1

Size: 1 Test

Shelf Life in Days: 24

KEY FEATURES

• Results in 5 minutes
• Reliable: Overall accuracy at 97%.
• Easy single procedure

1. Wash your hands with soap and rinse with clear warm water
2. Bring the pouch to room temperature before opening it. Open the foil pouch and get out the cassette.
3. Carefully pull off and dispose the released cap of the lancet
4. Use the provided alcohol pad to clean the fingertip of the middle or ring finger as the puncture site
5. Press the lancet, on the side from where the cap was extracted: against the fingertip (it is advisable the ring finger side). The tip retracts automatically and safely after use
6. Keeping the hand down massage the end that was pricked to obtain a blood drop.
7. Without squeezing the capillary dropper bulb, put it in contact with the blood. The blood migrates into the capillary dropper through the capillarity to the line indicated on the capillary dropper. You may massage again your finger to obtain more blood if the line is not reached. As far as possible, avoid air bubbles.
8. Put the blood collected into the sample well the cassette, by squeezing the dropper bulb.
9. Wait for the blood to be totally dispensed in the well. Unscrew the cap of the buffer bottle and add 1 drop of buffer into the sample well of the cassette.
10. Wait for the coloured line(s) to appear. Read results in 5 minutes. Do not interpret the result after 10 minutes.

Storage Temperature: Store below 30C

"Please read all the information in this package insert before performing the test.
-For self-testing in vitro diagnostic use only
-Do not eat, drink or smoke in the area where the specimens of kits are handled
-Store in a dry place at2-30 degrees, avoiding areas of excess moisture. If the foil packaging is damaged or has been opened, please do not use.
-This kit is intended to be used as preliminary test only and any negative results should be discussed with doctor or medical professional
-Follow the indicated time strictly
-Use the test only once. Do not dismantle and touch the test window of the test cassette."

IMPORTANT INFORMATION

"Please read all the information in this package insert before performing the test.
-For self-testing in vitro diagnostic use only
-Do not eat, drink or smoke in the area where the specimens of kits are handled
-Store in a dry place at2-30 degrees, avoiding areas of excess moisture. If the foil packaging is damaged or has been opened, please do not use.
-This kit is intended to be used as preliminary test only and any negative results should be discussed with doctor or medical professional
-Follow the indicated time strictly
-Use the test only once. Do not dismantle and touch the test window of the test cassette."